Nursing Elites

1. Which characteristic does a transverse wave not have?

• A. a compression
• B. an amplitude
• C. a frequency
• D. a wavelength

Correct answer: A

Rationale: A transverse wave does not have a compression because transverse waves move perpendicular to the direction of the oscillation. In a transverse wave, the particles move up and down, causing crests and troughs, without creating compressions. Compressions are characteristic of longitudinal waves where the particles move parallel to the direction of the wave. The other choices (B, C, and D) are characteristics that transverse waves possess: amplitude is the maximum displacement of a wave from its equilibrium position, frequency is the number of complete oscillations a wave makes in a given time, and wavelength is the distance between two consecutive points in a wave that are in the same phase.

2. What is the diameter of a loop if its radius is 6 meters?

• A. 6 m
• B. 12 m
• C. 18 m
• D. 36 m

Correct answer: B

Rationale: The diameter of a loop is calculated by multiplying the radius by 2. Since the radius is 6 meters, the diameter is 6 × 2 = 12 meters. Therefore, the correct answer is 12 meters. Choice A (6 m) is the radius, not the diameter. Choices C (18 m) and D (36 m) are incorrect as they do not reflect the correct calculation for determining the diameter of a loop.

3. When a fluid flows past a solid object, a thin layer of fluid adheres to the object's surface due to:

• A. Buoyancy
• B. Bernoulli's principle
• C. Boundary layer effect
• D. Surface tension minimization

Correct answer: C

Rationale: The boundary layer effect occurs when a thin layer of fluid near the surface of a solid adheres to it due to viscosity. This layer experiences a velocity gradient as the fluid farther from the surface moves faster, while the fluid closest to the surface is nearly stationary.

4. A 120-volt heat lamp draws 25 amps of current. What is the lamp’s resistance?

• A. 96 ohms
• B. 104 ohms
• C. 150 ohms
• D. 4.8 ohms

Correct answer: D

Rationale: To find the resistance of the lamp, we use Ohm’s Law, which states that resistance (R) is equal to voltage (V) divided by current (I), expressed as: R = V / I. Given that the voltage (V) is 120 volts and the current (I) is 25 amps, we substitute these values into the formula: R = 120 V / 25 A = 4.8 ohms. Therefore, the resistance of the lamp is 4.8 ohms. Choice A, 96 ohms, is incorrect as it is not the result of the correct calculation. Choice B, 104 ohms, is incorrect as it does not match the calculated resistance. Choice C, 150 ohms, is incorrect as it is not the correct resistance value obtained through the calculation.

5. A 0-kg block on a table is given a push so that it slides along the table. If the block is accelerated at 6 m/s2, what was the force applied to the block?

• A. 0 N
• B. 3 N
• C. 6 N
• D. The answer cannot be determined from the information given.

Correct answer: A

Rationale: According to Newton's second law of motion, F=ma. Since the block has a mass of 0 kg, the force applied must be 0 N, as no force is needed to move an object with zero mass.

Similar Questions